Garage Door Garage Door Sensor Installation Granville South, OH

Garage Door Garage Door Sensor Installation Granville South, OH

Garage door sensor installation in Granville South, OH is routine work for us. Local failure modes — humidity-swollen wood doors in summer, warped or sagging panels after years of freeze-thaw, rusted hardware from snowmelt and road salt, and loosened hardware from wide seasonal swings — are exactly what our trucks are stocked for.

Granville South sits in Ohio's continental-climate region — a humid continental climate — hot, humid summers and cold, snowy winters, with sharp freeze-thaw swings between seasons. That puts real stress on garage door hardware: we routinely see road salt and snowmelt that corrode the lowest hardware, summer heat and humidity that swell wood doors and rust steel, and doors frozen to the slab on the coldest mornings, and we fit parts rated to handle it.

From Granville South and the surrounding area, the issues Granville South customers describe are typically humidity-swollen wood doors in summer, warped or sagging panels after years of freeze-thaw, rusted hardware from snowmelt and road salt, and loosened hardware from wide seasonal swings. We quote flat-rate, fix it in one trip, and back the work for 10 years.

Photo-eye safety sensors are required by UL-325 on every garage door opener manufactured since 1993. They detect obstructions in the door's path and either reverse the door (during close) or refuse to start (when activated). When sensors are misaligned, dirty, sun-blinded, or failed, the door either refuses to close at all or — worse — closes without sensing an obstruction. Our sensor installation service replaces failed sensors, realigns drifted brackets, cleans the eye optics, and verifies auto-reverse on a real obstruction test.

Replacement eyes are brand-specific (LiftMaster has a different connector and signal pattern than Genie). We stock the major brands and most legacy models. Brackets occasionally need replacement when corrosion has degraded them or impact has bent them. Bracket alignment is critical — eyes that are slightly off-aim trigger intermittent close failures that drive homeowners crazy.

Every visit ends with an obstruction test: a 1.5-inch (3.8 cm) tall object placed under the door at three positions across the opening. The door must reverse when it touches the object. This is the UL-325 baseline — if the door doesn't pass, the install isn't complete. We document the test results on the work order.

Signs you need garage door sensor installation